English
Checking the package contents
Check the contents of the package for completeness immediately after
unpacking:
§
one kit, containing the components listed in the parts list (see
page I.1) and one PCB or
§
one ready-built module,
§
one manual.
Required tools and consumables
Make sure you have the following tools, equipment and materials ready
for use:
§
an electronic soldering iron (max. 30 Watt) with a fine tip,
§
a soldering iron stand,
§
a tip-cleaning sponge,
§
a heat-resistant mat,
§
a small side cutter and wire stripper,
§
a pair of tweezers and long nose pliers (not necessary for the
ready-built module),
§
tin solder (0,5 mm. diameter),
§
wire (diameter: > 0,25 mm² for all connections),
§
an electric light bulb for testing the module,
§
if necessary, two push-button switches for programming the
module.
Safe and correct soldering
!
Caution:
Incorrect soldering can cause dangers through fires and heat. Avoid
these dangers by reading and following the directions given in the
Page 36
PZS-3