Table of Contents
Advertisement
LD-G-14
Ambient temperature in storage
Comparative humidity allowed
Dimensions
Weight
Checking the package contents
Check the contents of the package for completeness after unpacking:
§
one decoder
§
one manual
N.B. For technical reasons it is possible that the PCB is not completely
inserted. This is not a fault.
Required tools and consumables
Make sure you have the following tools and materials ready for use:
§
an electronic soldering iron (max. 30 Watt) with a fine tip,
§
a soldering iron stand,
§
a tip-cleaning sponge,
§
a heat-resistant mat,
§
a small side cutter, a wire stripper and a pair of tweezers,
§
wire, diameter: > 0,05 mm² up to a current of 1 A resp.
> 0,14 mm² (from a current of more than 1 A),
§
tin solder (0,5 mm. diameter).
§
When the total current consumption is more than 1,5 A: a heat
sink, e.g. a SMD heat sink with a base of 7 x 19 mm.
Safe and correct soldering
!
Caution:
Incorrect soldering can cause dangers through fires and heat. Avoid
these dangers by reading and following the directions given in the
chapter Safety instructions.
-10 - + 80° C
max. 85 %
approx. 26 x 19 x 7,5 mm
approx. 3,5 g
English
Page 39
Advertisement
Table of Contents
