Table of Contents
Advertisement
FCS-2
Checking the package contents
Check the contents of the package for completeness after unpacking:
§
one module,
§
additional components: two resistors 10 Ω, one resistor 10 kΩ, one
light sensitive resistor, one diode 1N4148, one transistor BC 327,
one reed contact, one Dim switch DS-1,
§
one manual.
Required tools and materials
Make sure you have the following tools and materials ready for use:
§
an electronic soldering iron (max. 30 Watt) with a fine tip,
§
a soldering iron stand,
§
a tip-cleaning sponge and a heat-resistant mat,
§
a small side cutter and wire stripper,
§
a pair of tweezers,
§
tin solder (0,5 mm. diameter),
§
enamelled copper wire or thin connecting wire,
§
LEDs for the lights.
Safe and correct soldering
!
Caution:
Incorrect soldering can cause dangers through fires and heat. Avoid
these dangers by reading and following the directions given in the
chapter Safety instructions. If you have had training in soldering you
can skip this chapter.
§
Use a small soldering iron with max. 30 Watt. Keep the soldering tip
clean so the heat of the soldering iron is applied to the solder point
effectively.
§
Only use electronic tin solder with flux.
English
Page 23
Advertisement
Table of Contents
