Table of Contents
Advertisement
FCS-2
§
Only use low power for this module as described in this manual and
only use certified transformers.
§
Connect soldering irons only in approved mains sockets installed by
an authorised electrician.
§
Observe cable diameter requirements.
§
After condensation build up, allow a minimum of 2 hours for
dispersion.
§
Use only original spare parts if you have to repair the kit or the
ready-built module.
Fire risk
Touching flammable material with a hot soldering iron can cause fire,
which can result in injury or death through burns or suffocation.
Connect your soldering iron or soldering station only when actually
needed. Always keep the soldering iron away from inflammable
materials. Use a suitable soldering iron stand. Never leave a hot
soldering iron or station unattended.
Thermal danger
A hot soldering iron or liquid solder accidentally touching your skin can
cause skin burns. As a precaution:
§
use a heat-resistant mat during soldering,
§
always put the hot soldering iron in the soldering iron stand,
§
point the soldering iron tip carefully when soldering, and
§
remove liquid solder with a thick wet rag or wet sponge from the
soldering tip.
Dangerous environments
A working area that is too small or cramped is unsuitable and can cause
accidents, fires and injury. Prevent this by working in a clean, dry room
with enough freedom of movement.
English
Page 19
Advertisement
Table of Contents
