Special Features Of The Additional Components - tams elektronik FCS-2 Manual

Vehicle module compatible to the faller car-system

Hide thumbs Also See for FCS-2:

Manual (44 pages)

Table Of Contents

Table of Contents

English

When soldering electronic circuits never use soldering-water or

soldering grease. They contain acids that can corrode components

and copper tracks.

Solder quickly: holding the iron on the joints longer than necessary

can destroy components and can damage copper tracks or

soldering eyes.

Apply the soldering tip to the soldering spot in such a way that the

wire and the soldering eye are heated at the same time.

Simultaneously add solder (not too much). As soon as the solder

becomes liquid take it away. Hold the soldering tip at the spot for a

few seconds so that the solder flows into the joint, then remove the

soldering iron.

The joint should be held still for about 5 seconds after soldering.

To make a good soldering joint you should use a clean and

unoxidised soldering tip. Clean the soldering tip with a damp piece

of cloth, a damp sponge or a piece of silicon cloth.

After soldering check (preferably with a magnifying glass) tracks for

accidental solder bridges and short circuits. This would cause faulty

operation or, in the worst case, permanent damage. You can

remove excess solder by putting a clean soldering tip on the spot.

The solder will become liquid again and flow from the soldering

spot to the soldering tip.