1. Machine wire harness
2. Arm support
3. 2-wire branch (kit wire
harness)
4. Support channel
3.
Assemble the 2 single-receptacle terminals onto
the spade terminals of the momentary switch
(Figure
7).
3
Removing the Electrical
Panel Cover
No Parts Required
Procedure
1.
Move the operator's seat fully forward.
2.
Loosen the knobs that secure the electrical-panel
cover to the machine, and remove the cover
(Figure
8).
Figure 7
5. Front of the machine
6. 2 single-receptacle
terminals (2-wire
branch—kit wire harness)
7. Spade terminals
(momentary switch)
1. Knobs
2. Electrical-panel cover
4
g320702
Installing the Kit Wire
Harness at the Electrical
Panel
No Parts Required
Routing the Kit Wire Harness to
the Electrical Panel
Route the branch of the wire kit harness with the
spade connector and the 5-socket connector along
the platform wire harness of the machine, and toward
the fuse block
(Figure
5
Figure 8
3. Electrical plate
4. Grommet
9).
g320789