Toro 140-5800 Installation Instructions Manual page 4

Figure 4
1. Right side of the machine
2. Momentary switch
2. Inside the control console, secure the switch to
the panel (Figure 4) with the washer (5/8 inch)
and jam nut (5/8 inch).
3. At the outboard side of the control console,
adhere the decal to the left console panel as
shown in Figure 5.
Figure 5
1. Decal
g320615
3. Washer (5/8 inch)
4. Jam nut (5/8 inch)
g320703
Connecting the Kit Wire Harness
to the Momentary Switch
1. Position the kit wire harness behind the seat and
control console as shown in
2. At the back of the control console, route
the 2-wire branch (the branch with 2
single-receptacle terminals) of the kit wire
harness along the platform wire harness and
into the console
4
Figure 6.
Figure 6
(Figure 7).
g320701