Siemens SQN72 Series Manual page 10

Technical data
Actuator
10/20
Smart Infrastructure
Mains voltage
Mains frequency
Actuator motor
Internal consumption
Positioning angle, usable range
Mounting position
Degree of protection
Please note!
The drive shaft bearing must be installed appropriately to protect
against direct exposure to water and dust, otherwise IP54 cannot be
guaranteed for the entire lifetime.
Protection class
External primary fuse (Si)
Cable entry
Cable strain relief
Cable connection
Ferrules
Direction of rotation (the opening facing the shaft)

SQN72

SQN73
Torque and holding torque
Running times
Pause times at change in direction of
rotation
230 V AC -15%/+10%
50 to 60 Hz ±6%
Synchronous motor
Max. 6 VA
Max. 160°, scale range 0–130°
Optional
IP54 in accordance with EN 60529:1991 +
A1:2000 + A2:2013 when using the cable
entry provided plus plastic washers for the
M fixing screws as shown in the
Dimensions chapter.
II according to EN 60730-1:2016 +
A1:2019 and EN IEC 60730-2-14:2019
6.3 AT (to be installed on site) according to
IEC 60127-2-5
Rubber grommet for the insertion of a
single sheathed cable with a maximum
diameter of 11 mm. The opening of the
rubber grommet must be suitably adapted
to the sheath diameter of the cable. To
ensure that the rubber grommet will be
tight, the cable must be correctly laid in
this area with no openings. The rubber
grommet is included in the scope of
delivery.
Cable strain relief bridge with 2 fixing
screws included in scope of delivery
2 plug-in spaces with connection terminals
Type CUM / manufactured by Stelvio
For the following connector types:

CUF 5-4 (plug-in space X1)

CUF 5-5 (plug-in space X2)
Recommended cross-sectional area of
stranded wire
Min. 0.5 mm² and max. 1.5 mm²
The connectors are not included in the
scope of delivery (order directly from
Stelvio).
Matching the cross-sectional area of the
stranded wire
Counterclockwise
Clockwise
Refer to Type summary
Refer to Type summary
>100 ms
CC1N7802en
8/11/2021