Available Accessories; Troubleshooting - Shark Navigator Lift-Away NV392 Owner's Manual

AVAILABLE ACCESSORIES

Crevice Tool
A
Gives you extended cleaning reach
for small spaces.
Wide Upholstery Tool
B
Wide cleaning path helps remove pet hair,
dust, and large debris from mattresses,
couches, curtains, lampshades, and other
delicate upholstered surfaces.
Dusting Brush
C
Dust shelves, lampshades, window blinds,
furniture, and other upholstered household
items.
Pet Power Brush
D
Designed to remove pet hair and ground-in
dirt from carpeted stairs and upholstery.
Multi-Angle Dusting Brush
E
Offers 5 different positions for cleaning
shelves, blinds, walls, ceiling fans, and more.
Adjust the angle of the brush to the desired
cleaning surface.
Dust-Away® Hard Floor Attachment
F
Durable enough to vacuum up the big
crumbs but gentle enough to wipe away
fine dust on hardwood and tile floors with
the washable and reusable microfiber pad.
Its swivel motion allows easy access to
hard-to-reach areas.
NOTE: Not all accessories come with all units. Please see the enclosed Quick Start Guide for your unit's
configuration. To order additional accessories, visit sharkaccessories.com.
s h a r kc l e a n . c o m
Vacuum is not picking up debris. No suction or light suction.
A
• Check filters to see if they need cleaning. Follow instructions for rinsing and air-drying the
filters before reinserting in the vacuum.
• Dust cup may be full; empty dust cup.
• Check hose, hose connections, nozzle, wand, pod, and accessories for blockages. Clear any
blockages found. Refer to Checking for Blockages section for more information.
Vacuum lifts area rugs.
• Make sure Power/Surface switch is set to Hard Floor (setting I).
• Suction is powerful. Take care when vacuuming area rugs or rugs with delicately sewn edges.
B
• To minimize suction, slide suction control collar to MIN.
Brushroll does not spin.
• If the Brushroll Indicator Light turns red, immediately turn off and unplug the vacuum.
Remove pod from floor nozzle and clear any blockages. Reconnect nozzle, plug in vacuum,
and turn on power.
• With the power on, recline the handle, which will automatically turn on the brushroll.
• Ensure that the Power/Surface switch is set to Carpet (position II) for brushroll to spin.
C
Vacuum turns off on its own or indicator light flashes red.
This vacuum is equipped with a motor-protective thermostat. If your vacuum overheats, the
thermostat will automatically turn the suction motor off. Perform the following steps to restart
the thermostat:
1. Turn vacuum off and unplug it.
2. Empty dust cup and clean filters. See Emptying the Dust Cup and Cleaning Filters.
D 3. Check for blockages in hose, accessories, and inlet openings.
4. Allow unit to cool for a minimum of 45 minutes.
5. Plug in vacuum and turn it on.
E
F
For all other issues, please call Customer Service 1-800-798-7398.

TROUBLESHOOTING

s h a r kc l e a n . c o m