Table of Contents
Advertisement
Step 5. Mounting PV Assembly on Pole
A. Place the PV module assembly so the holes on the clips line up with holes in the inside of the bucket.
Depending on the size of the panel you started with, your assembly may look different than what is
shown in the provided view, with the clips and rails facing in the opposite direction.
B. Attach the clips to the bucket. In each of the 4 mounting holes, use a 5/16-18 x 3/4" bolt and flat
washer on one side and a washer, lock washer and nut on the other. Torque the bolts to the specified
torque setting.
C. Set desired module tilt angle and torque the bolts to the specified torque setting.
support@tamaracksolar.com
Installation Manual
1-800-819-7236 Ext 556
UNI-SP/01A
Page 7
Advertisement
Table of Contents
