Table of Contents
Advertisement
Step 3: Attaching Clips to Rails
A. Attach the clips to the rails as determined by the bucket range diagrams (shown in previous step).
Example shown has the clips facing in on the inside of the rails that are facing out.
B. In each of the clip mounting holes, use a 5/16-18 x 3/4" bolt and flat washer on one side
and a flat washer, lock washer and nut on the other. Tighten these bolts finger tight
only at this time (these will be torqued after the assembly is finished and the tilt angle is
final.)
C. Note: For over-the-pole option, attach the clips on the middle set of holes on the panel supports, see
view on manual cover.
support@tamaracksolar.com
Installation Manual
1-800-819-7236 Ext 556
UNI-SP/01A
Page 5
Advertisement
Table of Contents
