Step 1. Measure Pv Mounting Hole Distance; Step 2. Mounting Rail Supports On Pv Module - Tamarack Solar UNI-SP/01A Installation Manual

Step 1: Measure PV Mounting Hole Distance
A. Lay the module(s) face down on a protected surface in the suitable orientation.
B. Measure the center to center distance between the inside mounting holes on the back of the PV
module as shown and make a note of it.
Step 2: Mounting Rail Supports on PV Module
A. Review the reference diagrams on next page to determine the orientation of the panel support
rails (facing in or out) and the end clips (facing in or out), based on the center to center hole
spacing of your solar module
B. Secure the rails to the solar module with a 1/4-20 x 3/4 inch bolt, lock washer, and hex nut in each
of the solar module mounting holes. See the top of page 5 for reference view.
C. Torque the bolts to the specified torque setting (see page 1).
support@tamaracksolar.com
Installation Manual
1-800-819-7236 Ext 556
UNI-SP/01A
Page 3