Skoda Karoq 2018 Workshop Manual page 50

Karoq 2018 ➤ , Kodiaq 2017 ➤
1.6/85; 2.0/110; 130; 140 kW TDI CR engine - Edition 06.2017
– Remove top toothed belt guard
⇒ "2.3 Removing and installing toothed belt guard",
page 96 .
Kodiaq
– Use the spindle - 10-222A/11- to raise/lower the engine until
the applicable screw is accessible on the engine support
bracket.
Karoq
– Use the hook - MP9-200/10 (10-222A/10)- to raise/lower the
engine until the applicable screw is accessible on the engine
support bracket.
Continued for all vehicles
Note
Screw -2- can only be removed after removing the engine support
bracket.
– Release screws -1, 2 and 3- and remove engine support.
Installing
Installation is performed in the reverse order, while paying atten‐
tion to the following:
– Insert screw -2- into the bore of the engine support bracket
before fitting the engine support bracket.
– Fit the engine support bracket.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
– Tighten screws -1- to -3- hand-tight.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
– Then tighten the screws with the specified tightening torque
and tightening order
– Install top toothed belt guard
⇒ "2.3 Removing and installing toothed belt guard",
page 96 .
– Install engine mount
⇒ "2.2 Removing and installing engine mount", page 24
42
Rep. gr.13 - Crankshaft group
⇒ page 43 .
.