Skoda Karoq 2018 Workshop Manual page 465

9 - Screw
❑ Tightening torque Pos. -9-
10 - Exhaust gas temperature sender 3 - G495-
❑ Removing and installing
⇒ "4.4 Removing and installing the exhaust gas temperature sender 3 G495 ", page 464
❑ the thread of the exhaust gas temperature sender is coated and must not be coated additionally with hot
bolt paste
❑ 2.0 l engines: 60 Nm
❑ 1.6 l engines: 45 Nm
11 - Lambda probe 1 in front of the catalytic converter - GX10-
❑ consists of: lambda probe - G39- and lambda probe heater - Z19-
❑ Removing and installing
⇒ "9.2.1 Removing and installing Lambda probe 1 after catalytic converter GX10 ", page 377
12 - Exhaust gas cleaning module
1.6/85; 2.0/110; 130; 140 kW TDI CR engine - Edition 06.2017
⇒ Item 9 (page 375)
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Karoq 2018 ➤ , Kodiaq 2017 ➤
4. Exhaust temperature regulation
457