Table 8-2. Submersible Radio Torque Specifications - Motorola ASTRO XTS 5000 Basic Service Manual

8-24
5. Install a new main seal O-ring (55) around the casting assembly (51).
6. Reassemble the housing assembly (2) to the radio.
7. Inspect the main seal (55) for proper seating. Observe carefully to ensure that the main seal
O-ring is not pinched between the housing (2) and the casting (51).
8.10.9.8 Vacuum Port Seal
To replace the vacuum port seal:
1. Remove the vacuum port plug (59), using a pair of needle-nosed pliers and pulling upward.
2. Inspect the casting seal surface for debris or damage. Remove any debris and replace the
casting if damaged.
3. Install a new vacuum port plug (59) by pressing it in, ensuring that the plug sits flat all around
the edges and it is flush with the casting.
Speaker Bracket Screw
8.10.9.9 Vent Port Seal
To replace the vent port seal:
1. Remove the seal label (62) that covers the vent port seal (61).
2. Remove the vent port seal (61).
3. Ensure that the casting's surfaces are clean and free from any adhesive or other foreign
materials.
4. Install a new vent port seal (61), covering the two vent port holes, in the small recessed area
in the casting. Ensure that no oily substances come in contact with the seal.
5. Install a new seal label (62) over the vent port seal (61) in the larger recessed area in the
casting. Press down evenly over the label's surface to ensure good adhesion.
July 16, 2004
Disassembly/Reassembly Procedures: Ensuring Radio Submergibility

Table 8-2. Submersible Radio Torque Specifications

Torque
Application
(in.-lbs)
Torque
(N•m)
2 0.23
Torque Bit
Part Number
66-80321B79
6881094C28-D