Motorola ASTRO XTS 5000 Basic Service Manual page 91

Disassembly/Reassembly Procedures: Ensuring Radio Submergibility
4. Install new antenna bushing gasket (54).
5. Install a new main seal O-ring (55) around the casting assembly (51).
6. Reassemble the housing assembly (2) to the radio.
7. Inspect the main seal (55) for proper seating. Observe carefully to ensure that the main seal
O-ring is not pinched between the housing (2) and the casting (51).
8.10.9.3 Controls Seal
To replace the controls seal:
1. Referring to
remove the housing assembly (2) from the radio.
2. Remove the speaker retainer screw (23).
3. Remove the speaker retainer (36).
4. Install the universal connector cover (5)
in place when the controls flex is removed.
!
C a u t i o n
5. Disconnect the controls flex (18) from the universal connector by disengaging the spring tab
on the backer from the catch features on the housing.
6. Disconnect the controls flex's (18) 22-pin connector from PTT area of the housing assembly
(2).
7. Referring to
page 8-11, remove the frequency knob, frequency insert, secure lever, lightpipe, volume
knob, volume insert, and O-ring.
8. Using a thin, flat-bladed screwdriver, unsnap the left snap of the controls bracket assembly
(34) first, then unsnap the right snap.
9. Remove the controls bracket assembly (34).
10. Remove and discard the controls seal (35).
11. Inspect the housing seal surfaces for debris. Remove any debris.
12. Install a new controls seal (35).
13. Reassemble the controls bracket assembly (34) into the housing (2) by snapping in the right
side of the bracket first, then snapping in the left side.
14. Referring to
page 8-11, install the frequency knob, new frequency escutcheon, new frequency insert,
secure lever, lightpipe, volume knob, new volume insert, and O-ring.
15. Reconnect the controls flex (18) to the universal connector and the PTT area of the housing
assembly (2). Ensure the spring tabs on the backer fully engage the catch features on the
housing.
16. Install a new main seal O-ring (55) around the casting assembly (51).
17. Reassemble the housing assembly (2) to the radio.
18. Inspect the main seal (55) for proper seating. Observe carefully to ensure that the main seal
O-ring is not pinched between the housing (2) and the casting (51).
6881094C28-D
Section "8.8.1 Separate the Casting and Housing Assemblies" on page
Removing the controls flex without installing the universal
connector cover may compromise the universal connector.
Section "8.6 Frequency Knob" on page 8-10
Section "8.6 Frequency Knob" on page 8-10
(see page 8-9). This will hold the universal connector
and Section "8.7 Volume Knob" on
and Section "8.7 Volume Knob" on
8-21
8-12,
July 16, 2004