ABB ACS850 Quick Start Up Manual page 13

Quick Start-up Guide for ACS850 with Standard Control Program 13
After the text "Done OK" appears on the control panel, press OK to complete the
firmware assistant.
In the Main menu, highlight ASSISTANTS and press
ENTER.
Highlight Firmware assistants and press SEL.
Highlight Reference select and press OK.
The following parameters will be set.
Note: Depending on the selections you make, the
routine may skip some of the parameters listed
below.
Select the control mode for external control
locations EXT1 and EXT2.
Speed: Speed control.
Torque: Torque control.
Min, Max, Add: Torque reference and speed
controller output are compared and the
mathematical function is applied (smaller, greater,
addition).
Depending on the selections, the speed or torque
reference source (or both) is defined next.
Speed reference set-up
Choose the number of constant speeds (if any) to use.
If you select any constant speeds, you are asked if the start direction should affect the
constant speed direction.
No: The sign of the constant speed directly determines the running direction when the
constant speed is activated.
Yes: The sign of the constant speed is multiplied by the value of the Direction signal to
determine the running direction when the constant speed is activated.
4 – Reference selection
LOC MAIN MENU
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT
LOC
ASSISTANTS
Firmware assistants
Application assistant
EXIT
LOC CHOICE
Select assistant
Start/Stop Control
Reference select
EXIT
12.03 Ext1 ctrl mode
12.05 Ext2 ctrl mode
1
ENTER
1
SEL
OK