Mechanical installation
March 2022
2. Fit the Tri Clamp.
3.4
Adjust display orientation (optional)
To improve field access to wiring or to better view the optional LCD display:
Procedure
1. Loosen the set screw until the level detector housing can rotate smoothly.
2. First, rotate the housing clockwise to the desired location.
3. Re-tighten the set screw.
28
Do not unscrew all the way. Rotating the housing, without this screw in place, can
damage the internal wiring.
If the desired location cannot be achieved due to thread limit, rotate the housing
counterclockwise.
Note
Do not attempt to rotate the display beyond the thread limits.
Figure 3-14: Housing Rotation
Torque 30 in-lb (3 Nm)
H3/32 in.
Reference Manual
00809-0100-4140
Reference Manual