Mitsubishi Electric MSZ-GS06NA - U1 Service Manual page 61

OPERATING PROCEDURE
4. Removing the nozzle assembly
(1) Remove the panel (Refer to section 1.) and the corner
box.
(2) Remove the indoor/outdoor connecting wire (Refer to
section 2 (2)-(7).).
(3) Remove the indoor electronic control P.C. board holder.
(4) Pull out the drain hose from the nozzle assembly and
remove the nozzle assembly.
5. Removing the horizontal vane motor
(1) Remove the nozzle assembly. (Refer to section 5.)
(2) Remove the screws of the horizontal vane motor unit.
(3) Disconnect the connector from the horizontal vane
motor.
(4) Remove the screws of the horizontal vane motor.
(5) Remove the horizontal vane motor from the horizontal
vane motor unit.
OBH874A
PHOTOS/FIGURES
Photo 5
Screws of horizontal vane motor unit
61