Table of Contents
Advertisement
Full Time System Diagnostics
The system continuously monitors all protected zones, even when it is not armed, and warns you if it detects a problem when
you turn off the ignition
.
1. Turn off the ignition.
2. If the siren chirps twice, the system has detected a problem.*
3. The status LED will flash to indicate the zone where the problem has been detected.
1 flash
=
door
3 flashes
=
hood / trunk
4 flashes
=
optional sensor
* The system must see the zone open or active for at least 20 seconds before the zone is determined to be defective. This
way, opening the car door before turning off the ignition will not cause the siren to emit the warning chirps.
Valet Mode
Allows you to temporarily disable the security system when the car is being service or turned over to a parking attendant.
To turn Valet Mode on or off:
1. Turn on the ignition.
2. Press and hold the override switch.
3. While holding the override switch, turn off the ignition.
• The siren will chirp once to indicate you have turned Valet Mode on.
• The siren will chirp twice to indicate you have turned Valet Mode off.
4. Release the override switch.
While Valet Mode is on, the LED will light solid and you can continue to lock and unlock your doors with the Remote
Transmitters, as well as operate the Auxiliary Functions.
For added protection, when the doors are locked using the Remote Transmitter, the siren will chirp twice, the system's Starter
Disable circuit will activate, and the LED will emit double flashes until the system is unlocked by the Remote.
If the Remote Transmitter is lost, stolen, or becomes inoperable while the car is locked in Valet Mode, you can exit the Valet
mode to deactivate the Starter Disable circuit.
Adding a New Transmitter into the System
Have all desired transmitters ready (up to 4 transmitters)
1. Turn on the ignition.
2. Press and hold the Override switch.
• The status LED will turn on red.
• The siren will chirp 5 times.
3. Within 5 seconds follow the steps below for each transmitter:
Continue holding the Override switch and Press Transmitter Button 1 for remote arming with chirp confirmation.
--- or ---
Release the Override switch and Press Transmitter Button 1 for remote arming without chirp confirmation.
• The status LED will flash once quickly to confirm that the new Remote Transmitter has been added.
4. Turn off the ignition.
• The siren will chirp 3 times to confirm that the new Remote Transmitters have been added.
Deleting Transmitters (Adding a Remote Transmitter and Erasing All Other Transmitters From the System)
Code all memory locations to delete any lost transmitters. Example: if two transmitters are used, after coding the first
transmitter, code the second transmitter three times to fill up the remaining memory locations.
Page 9 - MS2004 Installation Manual
Advertisement
Table of Contents
