HEIDENHAIN VT 121 Operating Instructions Manual page 48

Storage after removal
If the product is stored temporarily after removal, the
information on repackaging and the specified ambient
conditions must be complied with.
Further information: "Repackaging and storage", Page 37
Further information: "Specifications", Page 48
7.3 Disposal
Incorrect disposal of the device!
Incorrect disposal of the device can cause
environmental damage.
Do not dispose of electrical waste and
electronic components in domestic
waste
Forward the device to recycling in accor-
dance with the applicable local disposal
regulations
If you have any questions about the disposal of the
device, please contact a HEIDENHAIN service agency
48
NOTICE
8 Specifications
8.1 Overview
This chapter contains an overview of the product data
and drawings with the product dimensions and mating
dimensions.
8.2 Product data
Product
Housing Milled aluminum housing
Stainless steel base plate
Housing dimen- 98 mm x 74 mm x 84 mm
sions
Type of mounting Attached with two fixing clamps (ID
329454-02)
Electrical data
Supply voltage DC 19.2 V to 30 V (typical: DC
24 V)
Input power: max. 8.7 W
Reverse-polarity protection
X101: 12-pin A-coded M12
flange connector (male)
HEIDENHAIN vision systems must be powered through
LPS (see "Connecting the supply voltage", Page 43) and
PELV systems (for a definition, see EN 60204-1).
HEIDENHAIN | VT 121 | Operating Instructions | 03/2022