Table of Contents
Advertisement
Note: /
- SINGLE CLAMP /
1. All leads must not touch the high temperature parts which are
specified in safety specification (heat sink / FBT / power circuit /
etc.)
2. DY lead must be kept distant minimum 10 mm from FBT.
3. Anode lead must be kept distant minimum 10 mm from other
parts.
4. Dress AC cord to rear AV bracket properly.
5. Screen wire must be under L11 wire.
6. Screen and Focus wire strictly cannot touch CRT neck. and keep
distance from anode lead.
7. Woofer lead (A15) must not touch D804, D805 (hot part).
8. Screen Wire (Orange Colour) must be under L1.
9. DF32 and DF5 can't touch R5525 (hot part)
10. H16 Wire (Signal) can't near to AC cord for interferance reason.
- DOUBLE CLAMP / / Caution Points:
Advertisement
Table of Contents
