Table of Contents
Advertisement
B. Receive the cross hatch pattern.
C. Picture menu : DYNAMIC Normal and adjust BRIGHT DAC until
gray portion of cross hatch.
D. Set DY to CRT not to tilt (Up and Down and Left and Right).
3. ADJUSTMENT
A. Static Convergence Adjustment
a. Make sure that magnets are positioned shown in Fig. 1.
b. Adjust 4-pole magnets (Fig. 1) to align center dots of R and B
and adjust 6-pole magnets to align center dots to G.
c. After adjustment, secure magnets with magnet lock of white
lacquer. / *Beams move with rotating when static magnets
are turned. / Rotational reduce of beams differs by angle of
two magnets. / Therefore, repeat magnet adjustments several
times so that all are aligned completely.
B. YHC, YV, XV, Adjustment (Fig. 2)
a. Adjust so that Static and Dynamic Convergence is best with
YHC, VR, YV and XV coil. / In case of Static Convergence is
tilted, repeat (1) Static Convergence Adjustment.
C. Dynamic Convergence Adjustment
a. When dynamic convergence is bad, fixing permalloy between
Fig. 1
Fig. 2
Advertisement
Table of Contents
