Table of Contents
Advertisement
150-504-100-03
I
NSTALLATION
This section describes HRE-504 installation, including the following:
•
Unpacking and Inspecting the Shipment
•
Mounting the Enclosure
•
Grounding the Enclosure
•
Installing Doubler or Repeater Units
•
Detaching the Dome from the Baseplate
•
Opening the Enclosure
•
Closing the Enclosure
•
Pivoting the Enclosure
U
NPACKING AND
When you receive the equipment, inspect it for signs of damage. If damage has occurred, immediately report the
extent of damage to the transportation company and ADC. For additional information, see
Support" on page
43.
Your shipment should consist of:
•
One HRE-504
•
HiGain Remote Enclosure HRE-504 List 1 and List 2 Technical Practice
Before installing the HRE-504, unpack and inspect the shipment for missing components and physical damage
that may have occurred during shipping.
To unpack the enclosure:
1
Remove the HRE-504 from its shipping carton. Verify that all the equipment listed on the packing list is
present.
2
Inspect the enclosure, card cage, and O-ring for shipping damage.
3
If the equipment has been damaged in transit, immediately report the damage to the transportation company
and to your sales representative. Order replacement equipment, if necessary.
4
On the rearbase of the card cage, loosen the retaining screws.
5
Tilt the card cage on its hinge. Lower the card cage to its level position and tighten the screws to lock in
position. ADC recommends that the card cage be kept in a level, locked position.
If you must store the equipment for a prolonged period of time, store it in the container shipped
with your equipment.
HRE-504 List 1, List 1B, and List 2
I
NSPECTING THE
August 1, 2002
S
HIPMENT
Installation
"Appendix C - Product
7
Advertisement
Table of Contents
