Netcommand Controlled Peer-To-Peer Connections - Mitsubishi WS-48613 Owner's Manual

NetCommand
What is a Peer-to-Peer Connection?
Figure 1
A peer-to-peer connection allows the IEEE 1394 devices
in your TV network to talk to each other without the
further need of TV intervention once the peer-to-peer
connection is established.
For example, the TV can setup a connection for an A/V
Disc or DVCR that sends a recorded program to an
IEEE 1394 monitor in another room. NetCommand will
establish the connection between the two devices. Once
the connection has been established, the TV can be
turned off or used to watch another device. Recording
from Ant-DTV to a DVCR is also a peer-to-peer
connection. In this case the TV is one of the devices in
the peer-to peer connection.
Analog or traditional (non-digital) devices can not be
used for peer-to-peer connections.
Figure 1. Record screen
74
® Controlled Peer-to-Peer Connections
Setting up a Peer-to-Peer Connection
A peer-to-peer connection is a current connection and
cannot be setup as a delayed connection.
To establish a peer-to-peer connection:
1. Press REC on the TV remote.
2. Press DEVICE on the remote control to see the source
device choices that you can recording from.
3. Press ADJUST or
will record from.
4. Press ENT(er) to confirm selection and return to the
"Record to" section.
5. In the "Record to" section, review the destination
device (example: DVHS) and duration. Change if
necessary.
6. Press REC a second time to initiate recording.
NOTE: Multiple peer-to-peer connections can
occur simultaneously, sometimes with the same
source device. Also, please note that peer-to-peer
connections are NOT listed on the Record List
screen.
Canceling a Current Peer-to-Peer
Connection
When a peer-to-peer connection has been established,
you can cancel the connection by highlighting the source
device in the Device Selection menu. Confirm that the
on-screen icon for the peer-to-peer connection is in
the Connection Section next to the TV icon, then press
CANCEL. The peer-to-peer connection will end and the
destination icon will be removed. If there is more than one
peer-to-peer connection for the same device, all of the
connections will all be canceled.
to select the source device you