Mitsubishi WS-48613 Owner's Manual page 36

NetCommand
Review Screen
Figure 4
After you have made your device choices the Review
Screen will display. It is important to review the settings
to ensure that they are correct. If necessary, you can
use <Back to return to the Device Setup screen to make
changes.
Note: The Review screen lists the TV input and A/V
Receiver input used with each device. You must
correctly identify the inputs you used when you
connected the devices. If you have not connected
your devices, write down these inputs as a guide. If
you cannot use these inputs, or if you would like to
change the name of a device, use the instructions in
Edit NetCommand to make necessary changes.
Note: If you select Next> on the Review screen, all
selections made are finalized.
On the Review Screen, adding or deleting check marks
will turn the adjacent devices, memory cards or inputs On
or Off. If 1394 devices are not connected to the TV, the
1394 Name list will not appear on the Review screen.
Figure 4. Review screen
36
® Initial Setup, continued
Finish Screen
Figure 5
To finalize your selections and complete the
NetCommand setup, select Finish from the Finish
screen.
Note: If you wish to change any of the pre-
configured inputs or names for the devices, or add
devices not in the pre-configured setup, select
Edit to display Edit NetCommand menu.
If your A/V Receiver was not listed, select Edit to assign
all devices to new AVR inputs.
Figure 5. Finish screen
It is still necessary to memorize the available channels
for Antenna A, Antenna B and Antenna DTV. You may
do that by going to the TV Main menu and selecting
Antenna. Instructions to memorize channels are found
in the Antenna menu section.