Advanced Menu: Reset Factory Defaults, Convergence; Advanced Menu: Convergence - Mitsubishi WS-48613 Owner's Manual

Advanced Menu: Reset Factory Defaults, Convergence

Advanced Menu: Convergence

Figure 22
Select Advanced to perform the functions listed below.
Figure 22. Advanced Menu, Convergence
Your Mitsubishi TV has three picture tubes which need to
be aligned to properly converge the projected light beams
on the screen. Each picture tube projects a single color of
red, blue or green.
During production, your TV was carefully adjusted to
properly align these colors. However, moving the TV, the
TV's location in relation to the Earth's magnetic poles,
and the passage of time can cause these adjustments to
change.
As a special feature, you have the ability to adjust the
red and blue light beams in reference to the fixed green
light beam. This process is called convergence. There
are two separate memories for convergence. One, for
SD 480i/480p signals; the other for HD 1080i signals. SD
convergence should be adjusted while watching an SD
source and HD convergence should be adjusted while
watching an HD source.
The TV should be fully warmed up before adjusting
Convergence. Turn the TV On and wait at least 30
minutes before starting adjustments.
70
Reset Factory Defaults Menu
Figure 23
This allows you to reset the convergence to the original
factory settings. The message "Convergence reset
completed" will be displayed when the factory defaults
have been restored.
�������� ����� ����������� ��
������� ���������
��� ������ ������� �� ��� ��� ����
����������� ��� ������� �����������
���� �� ��������
����� ����� �� ����� ����������� ��
��� ���������
����� ���� �� ���� �� ������ �� ��� ����
������� ��������� ������������
Figure 23. Reset Factory Defaults Menu
Convergence Menu
Figure 24
When the Red and Blue crosshairs are properly
converged, the center-screen crosshairs will appear white.
You can press ADJUST
and Blue crosshairs. Press VIDEO to switch between Red
and Blue. Press AUDIO for the Advanced Convergence
screen, and see the next page for further instructions.
Red
Press ADJUST to converge the lines.
Press VIDEO to switch from Red to Blue.
Press MENU to go back.
Press CANCEL to delete changes.
Press AUDIO for Advanced Convergence.
Figure 24. Red Convergence Menu
, , or to move the Red