Mitsubishi Electric WD-60737 Owner's Manual page 74

74
Appendices
Appendix E: Troubleshooting, continued
Reset Name When to Use
A/V Reset To reset audio and
(for all inputs) video adjustments for
all inputs to the original
factory settings.
Channel
To erase and
Memorization re-memorize channels
on the ANT input.
Lock Menu To change your Lock
Pass Code menu pass code
Control-Panel To re-enable the
Lock Release control-panel buttons
after activation of the
Control-Panel Lock
Auto Input If the New Device
Sensing for Found screen does
HDMI not appear when you
connect an HDMI
device.
System Reset If the TV does not turn
on or off, does not
respond to the remote
control or control-
panel buttons, or has
audio but no video.
TV Reset To reset all consumer-
accessible settings
IMPORTANT:
and all memories to
Use this reset
the original factory
only if other
defaults.
troubleshooting
has been unsuc- Use TV Reset if the TV
cessful. can respond to con-
trols but TV behavior is
abnormal.
CAUTION: All owner-
performed setups and
adjustments will be
erased.
How to Use
While viewing the TV, press the
control-panel buttons ACTIVITY and
VOLUME DOWN at the same time for at
least two seconds.
1.
While viewing the TV, press
MENU to display the main menu.
2. Navigate to the Initial> Channel
menu.
3. Press ENTER.
4.
Highlight the reception mode,
e.g. Ant Air.
5. Highlight Scan.
6. Press ENTER to start channel
memorization.
See the cutout page from Appendix B,
page 65.
Press and hold the ACTIVITY button
on the control panel for ten seconds.
If the TV is powered off, you can
now press the POWER button to turn
it on.
1.
Disconnect the HDMI device.
2.
Delete the HDMI input in the
Inputs > Name menu (see page
40).
3. Power on and connect the new
device.
Press and hold the POWER button on
the control panel for ten seconds.
1. While viewing the TV, press
MENU to display the TV main
menu.
2. With the main menu displayed,
press number keys 1 2 3 to
display the Reset menu.
3. READ THE ON-SCREEN
WARNING AND INSTRUC-
TIONS.
• If you do not wish to use this
reset, press BACK or MENU to
back out.
• If you do wish to use the
reset, press ENTER to erase
all memories and settings.
Resulting Action
All Audio and Video settings are
returned to the original factory
settings, including Listen To,
Language, audio Balance,
Closed Captions, and Format.
All previously memorized chan-
nels for the antenna input are
erased and a new set of memo-
rized channels is created. To add
or delete individual channels, see
Initial > Channel > Edit menu
instructions on page 39.
Allows establishment of a new
code.
Allows the control panel to be
unlocked if the remote control is
misplaced.
The New Device Found screen
will display.
The TV will turn off. Power on the
TV and the green LED will flash
quickly for about one minute. The
changes you made most recently,
before using SYSTEM RESET, may
be lost.
The TV will start the initialization
process and then turn off.
Power on the TV and the front
green LED will start flashing. All
memory and settings outlined in
this Owner's Guide will need to
be set again.