Mitsubishi Electric WD-60737 Owner's Manual page 11

Setting Up TV Inputs, continued
About Auto Input Sensing/
Auto Output Sensing
This TV's Easy Connect™ Auto Input Sensing feature
detects most connections automatically.
Auto Input/Auto Output Sensing for Most Devices
When you first connect a device, the TV will:
a. Detect the connected device and automati-
cally switch to it.
b. Prompt you to identify the device type.
c. 837 Series. Prompt you to perform NetCom-
mand set-up for the device, if available.
d. Repeat these steps for other newly detected
devices.
Which Jacks Trigger Auto Sensing?
TV Jacks and
Auto Sensing
Y/VIDEO (detected as
composite video)
Y/VIDEO plus Pb (detected
as component video)
HDMI
USB (837 series)
DIGITAL AUDIO OUTPUT
(orange jack)
AVR AUDIO OUTPUT
(red jack)
ANT (Antenna)
IR NetCommand Output
(837 series)
The TV may not detect an HDMI device when
the device is powered off. Detection will
occur when the device is next powered on.
When You First Connect a Device
• Most Device Types.
the on-screen list. The device type you select here
will appear as a device icon in the Activity menu.
A/V Receiver
•
- The TV can detect audio connections on the
DIGITAL AUDIO OUTPUT jack and the right (red)
AVR AUDIO OUTPUT jack.








Select the device type from
1. Basic Setup and Operation
- For an HDMI A/V receiver, select
the list of device types if the A/V receiver is
not recognized automatically.
HDMI CEC Devices Compatible with the TV's
•
HDMI Control Feature. Compatible CEC-
enabled HDMI devices are often recognized auto-
matically by the TV. HDMI Control may allow you
to control some functions of a CEC-enabled device.
See Appendix C, "HDMI Control of CEC Devices."
New Device Found screen for a device with HDMI
control enabled. Select On to enable the TV's CEC
control of the device. In some cases, as in the
example above, you will also be prompted to select a
device name.
Tips on Auto Sensing
• Choose a different name for each input.
• The antenna input (
although you can turn off the unused antenna
input in the Inputs > Name menu.
• Change the device type displayed in the
menu by using the Inputs > Name menu (page
40).
• 837 series. Any "learned" NetCommand IR
codes will be erased if you change the device
type in the Inputs > Name menu.
Reactivating Auto Input Sensing
for an HDMI Input
When you disconnect an HDMI device, Auto Input
Sensing is disabled until you perform these steps.
1.
Disconnect the HDMI device.
2.
Delete the removed HDMI device in the
Name menu (see "Removing an HDMI Device,"
page 69).
3.
Connect the new device and the
Found screen will display.
AVR from
ANT) is never detected,
Activity
Inputs >
New Device
11