Setting Up Tv Inputs - Mitsubishi Electric LT-46244 Owner's Manual

14
2. TV Setup
Initial TV Setup, continued
Change the Menu Language
Choose to display on-screen menus in either English or
Spanish (Español).
Select a menu language in the Setup menu.
1. With the Setup menu displayed, press
light the Language icon.
to highlight either English or Spanish.
2. Press
3. Press MENU to return the highlight to the top row of
icons.
Memorize Channels (Channel Scan)
For ANT 1/MAIN and ANT 2/AUX
Start a channel scan (memorization) from the Setup
menu.
Note: If using a CableCARD, the TV will automatically
acquire the complete list of available channels
from the service provider. Perform channel
memorization for ANT 1 CableCARD service only
if you need to reacquire the channel list.
To start channel memorization
1. With the Setup menu displayed, press
light the Scan icon.
2. Press to highlight an input selection based on
your connections:
Input Condition
Ant 1 Air When connected to an indoor or
Ant 2 Air outdoor antenna
Ant 1 Cable When connected to direct cable (no
Ant 2 Cable cable box)
3. Press
4. Press ENTER to start automatic channel memoriza-
tion.
To stop channel memorization before
completion, press CANCEL.
5. When memorization is complete you can:
•
•
•
After channels have been memorized:
To tune to memorized channels, press CH
•
while watching TV on the ANT 1 or ANT 2 inputs.
• Use the Setup > Edit menu for additional channel
options, such as adding or deleting channels from
memory, naming channels, and saving favorite
channels in custom memory banks.
Additional TV Setup Using the Setup Menu
to high-
See chapter 5, "TV Menu Settings," to:
• Edit channel options
• Set the TV clock
• Set the TV Timer
• Select an Energy Mode to manage power use while
the TV is off.

Setting Up TV Inputs

When You First Connect a Device
This TV's Easy Connect™ Auto Input Sensing feature
detects most connections automatically. When you
first connect a device, the TV will:
a. detect the connected device and automatically
b. prompt you to identify the device type
c. prompt you to perform NetCommand set-up for
d. repeat these steps for any additional newly
The tables below state which connections trigger Auto
Input Sensing.
Auto Detection Active
INPUT video jacks
to high-
COMPONENT video jacks
*
HDMI
DIGITAL AUDIO OUT
AVR AUDIO OUTPUT, right (red) analog audio jack only
USB (USB photo port on side)
If the device is powered off when connected, detec-
*
tion occurs when the device is next powered on.
Note: For connection and setup of a personal com-
to highlight the on-screen START button.
Press MENU once to return to the top row of icons.
Press MENU again to return to the Main menu.
Press EXIT to watch TV.
switch to it
the device
detected devices
No Auto Detection
ANT 1 and ANT 2
puter, see the information later in this chapter.
/