Service And Support - Mitsubishi Electric LT-46244 Owner's Manual

Appendix E: Troubleshooting, continued
Reset Name When to Use
Lock Menu To change your Lock
Pass Code menu pass code
Side Panel To re-enable the side
Lock Release panel controls after
activation of the Side
Panel Lock
System Reset If the TV does not turn
on or off, does not
respond to the remote
control or side panel
buttons, or has audio
but no video.
TV Reset
To reset all consumer-
IMPORTANT: accessible settings
Use this reset and all memories to
only if all the original factory
other resets defaults.
have been
CAUTION: All owner-
unsuccessful.
performed setups and
adjustments will be
erased.

Service and Support

Service
If you are unable to correct a problem with your TV,
consult your Mitsubishi dealer or Mitsubishi Consumer
Relations at (800) 332-2119.
• DO NOT adjust any controls other than those
described in this Owner's Guide.
• DO NOT remove the protective back cover of your TV.
How to Use
See the cutout page in Appendix A.
Press and hold the MENU button
on the side panel for over eight
seconds.
Press the SYSTEM RESET button on the
side panel with a pointed object
such as the point of pencil or end
tip of a paperclip.
1. While viewing the TV, press MENU
to display the TV Main menu.
2. With the Main menu displayed,
press number keys 1 2 3 to
display the Reset menu.
3. READ THE ON-SCREEN
WARNING AND INSTRUC-
TIONS.
• If you do not wish to use this
reset, press EXIT or MENU to
back out.
• If you do wish to use the
reset, press ENTER to erase all
memories and settings.
Support
• To order replacement or additional remote controls
or Owner's Guides, visit our website at www.mitsu-
parts.com or call (800) 553-7278.
• For questions:
Call Consumer Relations at 800-332-2119.
E-mail: MDEAservice@mdea.com
Appendices
Resulting Action
Allows a new code to be
established.
Allows the side panel controls to
be unlocked if the remote control
is misplaced.
The TV will turn off and the blue
LED will flash quickly for about
one minute. When the blue LED
stops flashing, you may turn on the
TV. The changes you made most
recently, before using SYSTEM RESET,
may be lost. Changes you made
previously, however, are not lost.
The TV will start the initialization
process. The TV will then turn
off and the front blue LED will
start flashing. When the LED
stops flashing (about. 1 min.), you
can turn the TV on again. The
Parental Lock Pass code will
remain unaffected, but all other
memories and settings outlined in
this Owner's Guide will need to be
set again.
77