Using The Smoothie Bowl Maker - Ninja FOODI SS351 Series Owner's Manual

USING THE SMOOTHIE BOWL MAKER

IMPORTANT: Review all warnings on
pages 4–7 before proceeding.
NOTE: If the unit is plugged in and powered
on, but the bowl and blade assembly is not
properly installed, the timer will display - -"
and the motor will be disabled.
NOTE: Auto-iQ® programs have pauses and
changes in speed throughout the cycle.
1
Plug in motor base and place on a clean,
dry, level surface such as a countertop
or table.
2 Add ingredients to the Smoothie Bowl
Maker. DO NOT add liquid past the
LIQUID FILL line or ingredients past the
MAX FILL line.
3 Place the Hybrid Edge™ Blades Assembly
on the top of the bowl maker and turn
clockwise to seal.
16 ninjakitchen.com
4 Turn the bowl maker upside down and
install on motor base by aligning the tabs
on the bowl maker with the slots on the
base. Then, rotate bowl maker clockwise
until it clicks. Once locked in place, press
the Power button to turn unit on. The
available program buttons will illuminate
and the unit will be ready for use.
NOTE: While processing, twist the built-in
tamper counterclockwise continuously.
5a If using an Auto-iQ program, use the dial
select the program that best suits your
desired output, then press START/STOP.
During the blending process, ensure to
twist the built-in tamper counterclockwise
continuously. The preset feature will
automatically stop at the end of the
program. To stop the unit at any time,
press START/STOP.
5b For Manual mode, press IQ/MANUAL. With
speed 10 on the display, press START/STOP.
During the blending process, twist the built-in
tamper counterclockwise continuously. Once
the ingredients have reached your desired
consistency, press START/STOP and wait for
the unit to come to a complete stop.
NOTE: Only speed 10 is available when
using the bowl maker.
6 Remove the bowl maker from the motor
base by turning it counterclockwise and
then lifting up.
7 Remove the blade assembly by twisting
counterclockwise. DO NOT store blended
contents with the blade assembly
attached. Only use the Spout Lid or
Storage Lid to cover. Exercise care when
handling the blade assembly, as the
blades are sharp.
8 To enjoy on the go, place the Spout Lid
or Storage Lid onto the bowl maker and
twist lid clockwise until firmly sealed.
9 Turn the unit off by pressing the Power
button. Unplug the unit when finished.
Refer to the Care & Maintenance
section for cleaning and storage
instructions.
ninjakitchen.com 17