Ninja FOODI SS351 Series Owner's Manual page 4

IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ CAREFULLY BEFORE USE • FOR HOUSEHOLD USE ONLY
WARNING
38 If you find unmixed ingredients sticking
to the sides of the cup, stop the
appliance, remove the blade assembly,
and use a scraper to dislodge ingredients.
39 DO NOT open the pitcher's pour spout
cap while blender is operating.
40 If you find unmixed ingredients sticking
to the sides of the pitcher, stop the
appliance, remove the lid, and use a
spatula to dislodge ingredients. NEVER
insert your hands into the pitcher, as
you may contact one of the blades and
experience a laceration.
41 DO NOT attempt to remove the container
or lid from the motor base while the
blade assembly is still spinning. Allow the
appliance to come to a complete stop
before removing lids and containers.
42 If the appliance overheats, a thermal switch
will activate and temporarily disable
the motor. To reset, unplug the appliance
and allow it to cool for approximately
15 minutes before using again.
43 DO NOT expose the containers and
accessories to extreme temperature
changes. They may experience damage.
6
ninjakitchen.com
44 Remove the Hybrid Edge™ Blades
Assembly from the single-serve cup or
Smoothie Bowl Maker upon completion
of blending. DO NOT store ingredients
before or after blending them in the
cup or bowl with the blade assembly
attached. Some foods may contain
active ingredients or release gases that
will expand if left in a sealed container,
resulting in excessive pressure buildup
that can pose a risk of injury. For
ingredient storage in the cup, use only
Spout Lid or Storage Lid to cover.
45 The maximum wattage rating for this
appliance is based on the configuration
of the Hybrid Edge Blades Assembly and
single-serve cup. Other configurations
may draw less power or current.
46 DO NOT submerge the motor base or
control panel in water or other liquids.
DO NOT spray motor base or control
panel with any liquid.
47 DO NOT attempt to sharpen blades.
48 Turn off the appliance and unplug the
motor base before cleaning.
49 Unit is intended to create a dough ball.
It is NOT intended to continuously
knead. After dough ball forms, additional
kneading should be done by hand
on a work surface. If the unit moves
excessively on the work surface, remove
the dough ball and knead by hand.
SAVE THESE INSTRUCTIONS
ninjakitchen.com 7