Timing Of Replacing The Lamp - Mitsubishi XD95U User Manual

Timing of replacing the lamp

When the lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a
new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some instances the
lamp may explode.
The LAMP indicator light and TEMPerature indicator light will light up if the lamp becomes too hot. Turn the power off and let the
projector cool for 45 minutes. If the Lamp or LAMP indicator light still lights up after turning the power back on, please contact
your dealer. See "Indicators" on page 40
The following lamp warning displays will remind you to change the lamp.
Status
The lamp has been in operation for 2000 hours. Install a new lamp for
optimal performance. If the projector is normally run with Low selected
(See "Setting Lamp mode as Low" on page
the projector until the 2950 hour lamp warning appears.
The lamp has been in operation for 2950 hours. A new lamp should be fitted
to avoid the inconvenience when the projector runs out of lamp time.
The lamp has been in operation for 3000 hours.
It is strongly recommended that you replace the lamp at this age. The lamp is
a consumable item. The lamp brightness diminishes with use. This is normal
lamp behavior. You can replace the lamp whenever you notice that the
brightness level has significantly diminished. If the lamp is not replaced
beforehand, it must be replaced after 3000 hours usage.
The lamp MUST be replaced before the projector will operate normally.
for details.
36), you may continue to operate
Message
Notice
Order Replacement Lamp
Lamp > 2000 Hours
OK
Notice
Replace Lamp Soon
Lamp > 2950 Hours
OK
Notice
Replace Lamp Now
Lamp > 3000 Hours
Lamp usage time exceeded
OK
Notice
Lamp-usage time exceeded
Replace lamp (refer to user manual)
Then reset lamp timer
OK
EN-37