Table of Contents
Advertisement
7.
Tighten the screw that secures the lamp.
•
Loose screw may cause a bad connection, which could result in
malfunction.
•
Do not over tighten the screw.
8.
Ensure the handle is fully laid flat and locked in place.
9.
As shown in the figure, replace the lamp cover on the projector.
10. Tighten the screws that secure the lamp cover.
•
Loose screw may cause a bad connection, which could result in
malfunction.
•
Do not over tighten the screws.
11. Restart the projector.
Do not turn the power on with the lamp cover removed.
Resetting the lamp timer
12. After the startup logo, open the On-Screen Display (OSD) menu. Go to
the SYSTEM SETUP: Advanced > Lamp Settings menu. Press
MODE/ENTER. The Lamp Settings page displays. Press
Reset lamp timer and press MODE/ENTER. A warning message
displays asking if you want to reset the lamp timer. Highlight Reset and
press MODE/ENTER. The lamp time will be reset to '0'.
•
Do not reset if the lamp is not new or replaced as this could cause damage.
This projector uses a lamp that contains mercury. Disposal of the lamp
•
or the projector with the lamp may be regulated due to environmental
considerations. For disposal or recycling information, please contact
your local authorities or the Electronic Industries Alliance:
www.eiae.org. (For US only).
to highlight
EN-39
Advertisement
Table of Contents
