Table of Contents
Advertisement
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. It occurs
when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, you will need to manually correct it following one of
these steps.
•
Using the remote control
Press
/
on the projector or remote control to display the Keystone
correction page. Press
to correct keystoning at the bottom of the image.
•
Using the OSD menu
1.
Press MENU and then press
highlighted.
2.
Press
to highlight Keystone and press MODE/ENTER. The
Keystone correction page displays.
3.
Press
to correct keystoning at the top of the image or press
correct keystoning at the bottom of the image.
Magnifying and searching for details
If you need to find the details on the projected picture, magnify the picture. Use the direction arrow keys for
navigating the picture.
•
Using the remote control
1.
Press MAGNIFY +/- to display the Zoom bar.
2.
Press MAGNIFY + to magnify the center of the picture. Press the key
repeatedly until the picture size is suitable for your need.
3.
Use the directional arrows ( ,
control to navigate the picture.
4.
To restore the picture to its original size, press AUTO. You can also
press MAGNIFY -. When the key is pressed again, the picture is further
reduced until it is restored to the original size.
•
Using the OSD menu
1.
Press MENU and then press
2.
Press
to highlight Magnify and press MODE/ENTER. The Zoom bar displays.
3.
Repeat steps 2-4 in the section of
panel, continue to the following steps.
4.
Press
on the projector repeatedly to magnify the picture to a desired size.
5.
To navigate the picture, press MODE/ENTER to switch to the panning mode and press the directional arrows
( ,
,
6.
Use the directional arrows ( ,
7.
To reduce size of the picture, press MODE/ENTER to switch back to the zoom in/out functionality, and press
AUTO to restore the picture to its original size. You can also press
original size.
The picture can only be navigated after the picture is magnified. You can further magnify the picture while searching for details.
EN-22
to correct keystoning at the top of the image. Press
/
,
/
until the DISPLAY menu is highlighted.
"Using the remote control"
,
) to navigate the picture.
,
until the DISPLAY menu is
,
) on the projector or remote
above. Or if you are using the projector control
,
) on the projector or remote control to navigate the picture.
to
/ .
Press
repeatedly until it is restored to the
/ .
Press
Advertisement
Table of Contents
