Intex Krystal Clean Poolwater 8221 Owner's Manual page 8

Set Up Instructions (cont.)
Saltwater System/Filter Pump
1. Remove the Saltwater System/Filter Pump and hoses from the packaging.
2. Place the Saltwater System/Filter Pump in a location for hose (5NF19) connections to the plunger
valve assemblies.
Note: Some regional regulations may require the filter pump to be mounted on a stationary
platform. There are two (2) mounting holes located in the pump base for this reason.
Consult your local authorities for filter pump mounting requirements.
3. Grasp the two (2) pump hoses (5NF19) and connect the hose nuts to the Saltwater Pool
System/Filter Pump.
4. In a counter-clockwise motion unscrew the threaded filter housing collar (6F16) from the filter
housing. Place it in a safe place.
5. The Saltwater System/Filter Pump is an airtight system. In a counter-clockwise motion turn both air
release valves (5F12 & 05F-37) 1 - 2 turns to open. DO NOT remove air release valves as water
will expel with force if the motor is turned on and injury may occur.
6. Grasp and remove the filter housing cover (6F14). Check to see if a cartridge is inside the housing.
If yes, replace the cover, finger tighten the housing collar (6F16) back onto the filter housing.
7. Gently finger tighten the sediment release valve located at the bottom of the housing to be sure
that water does not leak out.
8. When the pool is filled connect the hose from the electrolytic cell outlet to the highest strainer
assembly. The hose connection is made at the bottom of the plunger valve assembly. Use the hose
nut to attach the hose.
9. Connect the 2nd hose to the middle of the motor housing and to the remaining liner connection.
To prevent air lock, open the lower plunger valve (connected inlet hose) first and then the upper
plunger valve (connected outlet hose). Open air release valves, wait until water starts to flow out of the
air release valves, close air release valves.
SAVE THESE INSTRUCTIONS
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5" X 10.5" 09/18/2006
IMPORTANT
Page 8
104