Set Up Instructions - Intex Krystal Clean Poolwater 8221 Owner's Manual

Set Up Instructions

IMPORTANT: The Saltwater System/Filter Pump must be installed as the last piece of pool
equipment in the water return line to the pool. This location extends the life of the titanium plates.
Strainer & Plunger Valve Set Up (16' and below AGP)
The Saltwater System/Filter Pump assembly includes two (2) strainer-control mechanisms that are to
be installed in the pool liner's two (2) protruding hose connections with adaptor B. The strainer grid
prevents large objects from jamming and/or damaging the filter pump and the plunger valve assembly
prevents water from flowing into the filter pump while the filter cartridge is being placed or cleaned.
Install the strainer and plunger valve before inflating the pool liner top ring.
06NF-30
5F11
1. Grasp the strainer and plunger valve mechanism.
2. In a counter-clockwise motion unscrew plunger valve union from the threaded strainer connector
(06NF-02). Be careful not to lose the step rubber washer (06NF-05).
3. Grasp the plunger valve assembly. Make sure the step washer (06NF-05) is in place. Connect
adaptor B (05CG-12) to plunger valve union.
4. Repeat steps 1 through 3 for another plunger valve.
5. Remove wall plug and then insert the strainer (F12) into each of the protruding hose connection.
Adaptor B (05CG-12) fit over the strainer inserted into the connection.
6. Examine the plunger valve to see if the handle is pushed fully down to the "0/1" position. If not,
then grasp the handle at the top and push down turning the handle in a clockwise direction until the
plastic protruding notch anchors in the "0/1" position. This will prevent water from flowing out during
filling.
7. Repeat steps 1 through 6 for the 2nd protruding hose connection.
8. The pool liner is now ready to fill with water. Consult the above-ground-pool owner's manual for
filling instructions.
SAVE THESE INSTRUCTIONS
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5" X 10.5" 09/18/2006
06NF-05 05CG-12
---- INTERVAL FOR POOL FILLING ----
Page 6
LINER
F12
104