Operating Instructions (cont.)
7. The green and yellow LED lights on the control panel will disappear when the
cycle has ended. The system will go into a "Stand-By Mode" with the LED
flashing "93". The system automatically goes into a "Power Saving Mode" and
will automatically turn itself back on in 24 hours to continue its daily chlorine
production.
8. The LED will be become blank after 1 hour indicating the Saltwater System
is dormant (Power Saving Mode) waiting for the next startup cycle to begin.
Press any button (
SPECIAL NOTES
Always use a test strip to test the chlorine level before entering or using the pool. If the chlorine
•
level is too high, wait until the chlorine level drops below 3 ppm before using the pool or
operating the Saltwater System again.
IMPORTANT: Never use the pool if chlorine level is more than 3 ppm. Do not operate
•
Saltwater System while the pool is in use or occupied.
If a power outage occurs or the power cord is unplugged then the Saltwater System operating
•
hours will have to be reset.
SAVE THESE INSTRUCTIONS
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5" X 10.5" 09/18/2006
or
) to view the last LED code.
Page 15
104