ATEN CL5708IM User Manual page 155

Where xxxx represents the Username given to the user when the
account was created on the KVM over IP switch.
Use the same Username on both the RADIUS server and the
KVM over IP switch.
Use the same Group name on both the RADIUS server and the
KVM over IP switch.
Use the same Username/Group name on both the RADIUS server
and the KVM over IP switch.
In each case, the user's access rights are the ones assigned that were
assigned when the User of Group was created on the KVM over IP
switch. (See Adding Users, page 123.)
LDAP / LDAPS Authentication and Authorization Settings
To allow authentication and authorization for the KVM over IP switch via
LDAP / LDAPS, refer to the information in the table, below:
Item
Enable
Type
LDAP Server IP
and Port
Admin DN
Admin Name
Password
Search DN
Timeout
Put a check in the Enable checkbox to allow LDAP / LDAPS
authentication and authorization.
Click a radio button to specify whether to use LDAP or LDAPS.
Fill in the IP address and port number for the LDAP or LDAPS
server.
You can use the IPv4 address, the IPv6 address or the
domain name in the LDAP Server field.
For LDAP, the default port number is 389; for LDAPS, the
default port number is 636.
Consult the LDAP / LDAPS administrator to ascertain the
appropriate entry for this field. For example, the entry might
look like this:
ou=kn8132,dc=aten,dc=com
Key in the LDAP administrator's username.
Key in the LDAP administrator's password.
Set the distinguished name of the search base. This is the
domain name where the search starts for user names.
Set the time in seconds that the KVM over IP switch waits for
an LDAP or LDAPS server reply before it times out.
Chapter 10. Device Management
Action
139