Operating The Under-Bench Air Conditioner - Dometic FRESHWELL FW 3000 Operating Manual

Operating the under-bench air conditioner

8 Operating the under-bench air
conditioner
8.1 Basic notes on operation
The under-bench air conditioner has three operating modes:
Operating mode
Stand-by
On
The receiver switches on when it receives pulses from the remote control. The
display shows (flashing) the temperature setting, after 10 seconds the display shows
the room temperature, then it switches off.
You can use the remote control to
• switch the under-bench air conditioner to and from stand-by mode.
• adjust the settings
• select additional functions
8.2 Using the remote control
The remote control must be pointed at the IR receiver (fig. 2
receiver during operation.
When a button is pressed, the value is transmitted directly to the under-bench air
conditioner. The under-bench air conditioner confirms the receipt of data with a high
note.
Switching only the remote control to or from stand-by
In stand-by mode, the remote control display shows only the time.
If the remote control is not pointing to the IR receiver (fig. 2
control panel, you can activate the remote control or switch it to stand-by
independently from the under-bench air conditioner:
➤ Press the
button.
18
Features
The under-bench air conditioner is ready for operation and can be
switched on with the remote control.
The under-bench air conditioner is conditioning the air in the interior.
FreshWell3000
page 3) on the
4,
page 3) on the
4,
EN