Table of Contents
Advertisement
Can identify cable's type through the "Direct/Cross/other" indicator. And also can identify the cable whether
suitable 100M or Gigabit cable. Can display the remote number(Default is 255)
The 1-8 indicators on the cable tracer will flash in sequence according to the network cable sequence, will
display the cable type through the "Direct/Cross/other" indicator.
If need several different number other types cable testers, should pay the additional cost.
Cable tester-end/wire receiver-end fault location:
As shown above, the right side of interface is the continuity result of cable tester and wire receiver ports, the left
side is cable's sequence.
1）Cable tester-end/wire receiver-end display "x", it means the RJ45 cable connector of cable tester and wire
receiver or within 1 meter from the RJ45 cable connector of cable tester and wire receiver is faulty.
2) The middle part of sequence display "x", it means the RJ45 cable connector of Cable Tester/wire receiver is
normal, and there is a breakpoint 1 meter away from the RJ45 cable connector.
3) The middle part of sequence is not communicated and not display "x", it means the RJ45 cable connector of
Cable tester / Wire receiver is faulty, and the middle of the cable is normal.
9
Advertisement
Table of Contents
