Table of Contents
Advertisement
8. Specification
Item series
LCD
Display
UTP cable
test
Cable
test
and
Cable type
cable tracer
The fault of
RJ45 cable
connector
RJ45 TDR cable
Test cable pair status, length, attenuation, reflectivity, impedance, skew etc. measurement
test
range 180M.
Can test break point and short-circuit of cat 6e/5e (4 pairs), power line, BNC cable and
TDR cable test
Telephone line, etc. the MAX. 1.2km length.
Port flashing
Can search the Ethernet switch port which connect the meter
Check whether IP camera or other network equipment's Ethernet port is working normally,
PING test
the IP address whether is correct.
Quickly find the IP address of the IP camera or other network equipment which connected to
IP Scan
the meter
Quickly identify the connected network port (10/100/ 1000M) and duplex mode (full duplex
Link Monitor
/ half duplex).
External power
DC 5V/1A
supply
Battery
Built-in 3.7V Lithium Ion battery, 2000mAh. The cable Receiver battery: two AA batteries
Rechargeable
After charging 3 hours, normal working time 16 hours
Auto off
1-30 (mins)
Working
-10℃---+50℃
Temperature
Working
30%-90%
Humidity
Dimension/Weight
126mm x 83mm x 33mm / 0.34kg
Network tester & Cable tester
2.4 inch TFT-LCD screen , 320x240 resolution
Test UTP cable's sequence, type and remote kit, quickly detect the near-end,
mid-end and far-end fault point of RJ45 cable connector
RJ45 Twisted pair, RJ11 telephone line, BNC cable etc.
Can determine the fault point of RJ45 cable connector from
LOCAL/Remote indicator light
18
Advertisement
Table of Contents
