Table of Contents
Advertisement
2. Production Introduction
2.1 Feature
2.4 inch TFT-LCD screen, 320x240 resolution
●
Secondary code digital mode, decisively rejects noise and false signals, locate cables quickly and easily.
●
Advanced UTP cable test, test UTP cable's sequence, type and remote kit, quickly detect the near-end, mid-end
●
and far-end fault point of RJ45 cable connector.
RJ45 cable TDR test, test cable quality, length and attenuation.
●
HD Coaxial video level meter, can detect the TVI/CVI/AHD/CVBS signal peak value, SYNC value and burst
●
value.
Port Flash, can search the switch port which connect the meter.
●
PING test, check whether IP camera or other network equipment's Ethernet port is working normally, the IP
●
address whether is correct.
IP Scan, quickly find the IP address of the IP camera or other network equipment which connected to the meter.
●
Link status, quickly identify the connected network port (10/100/ 1000M) and duplex mode (full duplex / half
●
duplex)
TDR cable test 2.0, can test break point and short-circuit of cat 6e/5e (4 pairs), power line, BNC cable and
●
Telephone line, etc. the Max. 1.2km length
3.7 V /2000mAh Lithium Ion Battery, after 3 hours charging, working time lasts 18 hour
●
2.2 Packing list
1) Multi-function cable tester
2) Wire receiver
3) Adaptor DC5V 1A
4) Micro USD charging cable
5) RJ45 cable
6) RJ11 cable
7) TDR alligator clip cable
8) Polymer lithium ion battery (3.7V DC 2000mAh)
9) User Manual
2
Advertisement
Table of Contents
