Table of Contents
Advertisement
continuity of the line of the RJ45 cable connector or
within 1 meter from RJ45 cable connector. As shown on
the right, If the light is on, it means it is connected and
vice versa.
Connect the network cable into the cable
tester's RJ45 port, the other end of network cable
disconnect any device. Press "MUTE" button, when the
"Port" light on, can test the continuity and short circuit
status of network cable.
Extended function: For normal cables, the remote port
is unknown, and the 1236 or 1-8 lights are flashing,
which can be used to determine whether the remote end
is connected to a switch or router.
(Generally, 100M switches show that 1236 lines are connected, and Gigabit switches 1-8 lines are all connected)
(3) The UTP port of emitter and receiver can max 60V withstand voltage, the wire can be traced directly in
connection with PoE switch.
Note: The battery of the cable tracer must according to corresponding positive pole + and negative pole -,
otherwise will damage the tester.
4.1.2 UTP cable test
In "SCAN UTP " interface, connect the network cable to the "UTP/SCAN" port of cable tester, and the other end
connect to the UTP interface of receiver, can test cable's sequence, and display in the cable tester interface.
8
Advertisement
Table of Contents
