Table of Contents
Advertisement
TYRES:
Start by doing a visual check, looking for abnormal wear or cracks. If you think your tyre needs replacement based on this check up, you should
follow your instincts. You may bring your tyres to your local bike shop for a competent opinion. While doing your visual inspection, check for proper
tyre pressure by using a tyre gauge suited for testing bicycle tyres. The recommended tyre pressure is 30(max) PSI and is marked on the tyre's
sidewall. The maximum pressure will carry the maximum load capacity of your bicycle.
Bearing lubrication
The next maintenance step is to lubricate the bearings. Your bearings are the connection between the rotating wheels of your scooter and the
non-rotating frame that holds them stable. As you use your scooter, the friction can cause the bearing to get worn out - we prevent it from happen-
ing by lubricating it regularly.
Start by cleaning the bearings using with a clean and wet towel, you can spin the wheel at the same time which might make it easier for you to
clean. After your bearings are clean, it's really important for you to add lubricant to the bearings, if you don't they will get worn very rapidly.
Spray the lubricant generously. Spray directly at the bearings and in the general bearing direction, since they are sealed for better protection. Spin
your wheel at the same time to make sure the lubricant is dispersed effectively.
CLEANING YOUR ESCOOTER:
Basic cleaning information and maintenance guide.
Do not use a pressure washer to clean your eScooter. eScooters are not built to withstand high pressure water jets. Using a pressure washer
at full power has the potential to damage parts and can force excess water, dirt, and debris into places it shouldn't be in and wreak havoc on the
workings of the e scooter.
Do not use special car cleaner and soaps on an eScooter as most car soaps have wax in them which are not suitable for eScooters.
Typically, the best way to wash e scooter accessories is to wipe them down with a dry rag. Avoid getting any water or soap on the following parts:
The hub bearing (the center of the wheel)
The bottom bracket (where the pedals connect together through the frame)
The headset bearing (where the handlebars connect to the frame)
The brake pads and rotor, or discs
Chains, gears and motor
The first step when it comes down to how to wash an eScooter is to use a brush to clean the dry dirt from the rims and tyres of your e scooter. After
that, take a wet rag or sponge and wipe down the frame of your eScooter. Make sure to get to the underside of the frame where dirt is most likely to
gather. Once your eScooter has been thoroughly cleaned, rinse off all the dirty water. After the dirt residue has been cleaned from the eScooter use
a clean, dry rag to wipe the scooter dry.
Once you've wiped the scooter dry, lube the chain to prevent it from rusting. To do this, take your chain and run it through a clean dry rag to wipe off
any water that managed to get on it. Next, take chain lube and apply a slow but steady stream to the inside of the chain as you rotate the cranks until
the whole chain got lubed.
16
Advertisement
Table of Contents
