Performance Of The Pump; Battery Information - Profi-pumpe OASIS 501R-1 Operating Instructions Manual

Solar pond pump
Hide thumbs Also See for OASIS 501R-1:
Table of Contents

Advertisement

Available languages

Available languages

4 English
6.2 Operation from remote control
l (ON):
The Pump will be constantly on until battery runs out of all power.
l (2):
The pump will stay on for 2 hours an then switch off for 22 hours and will repeat this timing set every day at the
same time. For example: if you want to turn on every day at 5pm, you need to turn on the pump to 2 hours timer at
5pm. Pump will turn on every day at 5pm and turns off at 7pm.
l (3):
The pump will stay on for 3 hours an then switch off for 21 hours and will repeat this timing set every day at the
same time. For example: if you want to turn on every day at 5pm, you need to turn on the pump to 3 hours timer at
5pm. Pump will turn on every day at 5pm and turns off at 8pm.
l (4):
The pump will stay on for 4 hours an then switch off for 20 hours and will repeat this timing set every day at the
same time. For example: if you want to turn on every day at 5pm, you need to turn on the pump to 3 hours timer at
5pm. Pump will turn on every day at 5pm and turns off at 9pm.

7. PERFORMANCE OF THE PUMP

The performance of the pump depends on the orientation of the solar panels towards the sun and their intensity. The
max. Performance is achieved under optimum conditions. A function in the shade or under cloudy skies can not be
guaranteed. The solar pond kits are designed primarily for use in the summer months. However, the solar panel power
should be enough even on days in spring and autumn with excellent sunlight to operate. However, this can not be gua-
ranteed. For models with battery operation the function of the solar pond sets the charge state of the battery depends.
Depending on the pump version allows you to customize the delivery. If a controller is available at the pump, as in the
horizontal position is the max. achieved delivery. In a vertical position only little or no water is pumped. This model sets
the flow rate at the control panel of the battery case.

8. BATTERY INFORMATION

After 12 to 18 months, you should replace the battery. For this purpose unscrew the battery cover and replace the
battery with a new (replacement batteries available on request). Please note the limited implied warranty of 6 months.
Tools needed:
Medium sized Philips head screwdriver.
1. Remove the srews from battery box
2. Remove the lid and control panel from the battery box slightly.
3. Disconnect the old battery from the control panel and remove it from the
housing. Insert the new battery.
4. Carry out the assembly in reverse order.
IMPORTANT! It must be ensured that the battery cover is properly
tightened and watertight.
With repeated charge and discharge cycles Lead-Acid and NiMh battery
packs are less efficient (memory effect). This effect is much less pronounced,
but still present in small mass in the Li-ion batteries used.
Through very short and frequent loading operations and many
other operational influences batteries can age prematurely strong.
The batteries are therefore subject to a consumable and wearing
part of a shortened warranty of 6 months.
If you find that the battery will be less efficient, the battery needs
to be fully charged. These allow the unit for 2 to 3 days (pump should
not be connected) standing in the sun in order to
allow a maximum charge the battery or use a suitable external
charger. We recommend to occasionally repeat this procedure to extend the battery life.
If after this recharging the battery still does not meet expectations, you should replace the batteries.
NOTE: The battery is supplied charged. If the state of charge, contrary to expectations, not be sufficient to
charge the batteries for at least 8 hours to allow sufficient charging of the battery (so damage the battery to
avoid overcharging, the pump must be connected).
IMPORTANT!
You have to press the POWER button in battery
box to switch on battery system first, then you
can select function by pressing button on the
remote control.
Control panel
Lid
Battery
connector (black)
Battery
connector (red)
Battery
Battery box
Screws /4pc)

Advertisement

Chapters

Table of Contents
loading

Table of Contents