Mounting - Smeg SIB2741D Manual

Hob seal
To prevent leakage of liquid between the frame
of the hob and the countertop, place the
adhesive seal provided along the entire outer
edge of the hob before assembly.
Do not use silicone to secure the hob.
This would make it impossible to remove
the hob without damaging it.
Standard and flush mounting (mm)
MODEL (cm)
60
70
Electrical connection
1. Standard mounting
2. Flush built-in model

Mounting

Over built-in oven unit
The clearance between the hob and the kitchen
units or other built-in appliances must be enough
to ensure sufficient ventilation and air discharge.
If installed above an oven, a space must be left
between the bottom of the hob and the top of
the appliance installed below.
91477A677/A
X Y
555-560 478-482
555-560 478-482
In the case of flush mounting, after placing the
adhesive seal (A) on the glass surface and after
positioning and securing the hob, fill the edges
with insulating silicone (B) and wipe off any
excess. If for any reason the hob needs to be
removed, cut the silicone using a cutter before
attempting to remove it (C).
P Q
603 513
753 513
• With opening on bottom:
F G
88 317
88 317
INSTALLATION - 33