Dismantling; Storage; Disposal - nVent SCHROFF LHX+ User Manual

7.2

Dismantling

Outflow of cooling water can cause damage!

Works on the cooling water supply should be carried out by a refrigeration engineer
or suitably trained plumber.
Before any dismantling work can be started, the controller and cooling module must be
disconnected from the mains.
The cooling water supply and return must be closed and the cooling module must be drained.
Procedure:

Disconnect the power supply of the cabinet from the mains

Close the shut-off valves for the water supply and return.

Disconnect the screw connections for the water supply and return under the cabinet
floor, collect the leaking water.

Close the water supply and return lines on the cabinet to prevent the water remaining
in the heat exchanger from leaking out.
7.3

Storage


The cooling unit must be completely drained before storage.

If complete draining is not possible, flush the cooling unit with a suitable antifreeze
agent.

Ensure that the ambient conditions for storage comply with the specifications in the
"Technical data" chapter.

Protect the cabinet from dirt and moisture by using suitable packaging material.
7.4

Disposal

The system must be recycled in an environmentally friendly manner and disposed of
properly.
A specialized company can take over this task.
All regulations of the national legislation applicable in your country must be adhered to.
ATTENTION
Date: 2021/04/07 Page
: 38 of 47