Geometry Controls - Mitsubishi Diamond Pro 2070SB User Manual

Controls
–continued
Size and Position Controls
Auto Adjust: Automatically adjust the horizontal and vertical size and position settings for
the applicable timing signal.
NOTE: Auto Adjust is unavailable with no image signal or narrow size of image signal input.
Left/Right: Moves the image horizontally (left or right).
Down/Up: Moves the image vertically (up or down).
Narrow/Wide: Decreases or increases the horizontal size of the image.
Short/Tall: Decreases or increases the vertical size of the image.
Color Control/AccuColor
Color presets 1 through 5 selects the desired color setting. The bar is replaced by the
color setting choice from 1, 2, 3, sRGB, 5. Each color setting is adjusted at the factory to
the stated Kelvin degrees. If a setting is adjusted, the name of the setting will change from
Kelvin to Custom. NOTE: sRGB does not allow you to adjust each color.
Red, Green, Blue: AccuColor Control System decreases or increases the monitor's red,
green or blue color guns depending upon which is selected. The change in color will
appear on screen and the direction (decrease or increase) will be shown by the bars.
NOTE: sRGB does not allow you to control the AccuColor, Brightness and Contrast.

Geometry Controls

Geometry Controls Menu
The Geometry controls allow you to adjust the curvature or angle of the sides of your display.
In/Out (pincushion): Decreases or increases the curvature of the sides either inward or
outward.
Left/Right (pincushion balance): Decreases or increases the curvature of the sides either to
the left or right.
Tilt (parallelogram): Decreases or increases the tilt of the sides either to the left or right.
Align (trapezoidal): Decreases or increases the bottom of the screen to be the same as the top.
Rotate (raster rotation): Rotates the entire display clockwise or counterclockwise.
Corner Correction: Allows you to adjust the geometry of the corners of your display —
Top, Top Balance, Bottom or Bottom Balance.
Tools 1
Moiré Canceler: Moiré is a wavy pattern which can sometimes appear on the screen. The
pattern is repetitive and superimposed as rippled images. When running certain applications,
the wavy pattern is more evident than in others. To reduce moiré, adjust the level by using the
–/+ CONTROL buttons.
Convergence: Aligns all three colors (R,G,B) to form a single color (white). The purpose of
this control is to ensure that a white line drawn on the screen is as crisp and clear as
.
possible
• Use the CONVERGENCE (HOR.) control to adjust the alignment of the white lines in the left/right direction.
• Use the CONVERGENCE (VER.) control to adjust the alignment of the white lines in the up/down direction.
® Control System
6